Sikafloor®-94
Sikafloor®-94 is a 2 component epoxy - low viscosity primer for Sikafloor systems and a binder resin for general mortars.
- Low viscosity
- Excellent substrate penetration
- Very low odour - VOC
- Excellent binder for mortars
- Fast to cure
- Can be accelerated with Sikafloor Booster
- Economical
Usage
- Primer for concrete surfaces with Sikafloor resin systems
- Binder resin for epoxy mortar sub-fill mortar screeds
- Binder for epoxy coving mixes
- Flow and scratch coat layering prior to Sikafloor systems
Advantages
- Low viscosity
- Excellent substrate penetration
- Very low odour - VOC
- Excellent binder for mortars
- Fast to cure
- Can be accelerated with Sikafloor Booster
- Economical
Packaging
Available in a 30 kg kit and Bulk 200 kg Parts A+B
Colour
Yellowish transparent
Product Details
APPROVALS / STANDARDS
Potable Water certified to AS 4020 - 2014
VOC compliance to Aust. Green Building Codes V1.1-13.1.1 and V1.1-12.1.1B
Shelf Life
Stored in original sealed containers within the temperature range of +5 to +35 degress C, this product will keep for a minimum of 3 years
Storage Conditions
Stored in a dry place and out of direct sunlight within temperatures as mentioned above.
Density
1.1kg / litre (mixed)
Compressive Strength
> 40 MPa
Flexural Strength
22 MPa
Tensile Adhesion Strength
12 MPa approx - (to sandblasted steel)
Application
Mixing Ratio
Part A Part B = 2 :1 (by Mass and Volume)
Ambient Air Temperature
Application range recommended +5 to +30 Degrees C
Pot Life
At 10°C - approx. 30 mins.
At 20°C - approx. 20 mins.
Waiting Time / Overcoating
At 10°C, approx. 15 hours
At 20°C, approx. 8 hours
Note: Waiting times are approximately halved with the addition of Sikafloor® Booster.
Consumption
Primer
CSP 2-3 profile 5-6 m²/L approx.
CSP 4-5 profile 2-3 m²/L approx.
Mortar
Range of 1:5- 1:8 - mixed litre to kg blended Sika Aggregates
MIXING
Part A and B to be mixed the correct ratio for a minimum of 2 minutes
APPLICATION
Primer
Roll product evenly on and into the surface. If the product is completely absorbed then an additional coat should be applied within 24 hours.
Mortar
When used as a binder in profiling sreeds or coving mixes, the substrate should also be primed with Sikafloor®-94