Sikafloor® Level Eco

Green Star (VOC-SCQMD Rule 1168)

Polymer modified cement compound

Unopened bags can be stored for up to 9 months in a cool, dry and
weatherproof environment.

Bags must be stored off the floor. Avoid sitting bags in direct sunlight prior
to application.

  1 day cure – 15MPa
28 day cure – 30MPa

28 day cure – 5.5MPa

No hazardous combustion products are known

Porous

3.5 - 3.8 Litres of clean, cool water

3 - 75mm

10°C - 35°C

20 Minutes @ 23°C

Allow 24+ hours at 23°C prior to the application of floor coverings.

Drying is dependent on thickness of application, temperature, air flow &

relative humidity.

Increased air flow will help with drying speeds in cooler temperatures. 
Testing moisture content before applying floor coverings is recommended.

80 Minutes @ 23°C

12L - 4m2 @ 3mm thickness

• Use a double disc stirring paddle or a spiral mix
  paddle (low speed `300-400 rpm) and suitable size bucket/vessel -
  20L +
• Purpose built mechanical pump

Mix the entire 20kg bag of Sikafloor® Level Eco with

3.5 - 3.8 Litres of clean, cool water.

Slowly add powder to the water while mixing

thoroughly for 2 minutes to a lumpfree consistency.

Not mixing for the recommended time or additional

water may result in product irregularities and

possible product failure.

Pour or Pump Sikafloor® Level Eco, then spread with a
long handled gauged spreader to heights as required.
For touch-ups, use a flat steel trowel. If vinyls are

being installed a skim coat of Sikafloor® Level Pro

Finish (smoothing compound) may be required.

Areas of application must have fresh airflow to assist

with product hydration and drying.

Closed off rooms with no fresh air will retard the

curing process and effect product performance.

.

Second applications:

If required, a second coat may be applied as soon as the first coat is firm enough to walk on without causing excessive damage, approximately 2 hours @ 23°C but no later than 4 hours @ 23°C. 

This installation method is referred to as "wet-on-wet"

and higher temperatures/air flow will mean this

"wet-on-wet" second application time window is

reduced, therefore the second coat should always

be applied as soon as possible.

Note:

If the first application is allowed to dry past 4 hours

@ 23°C, re-priming & subsequent applications

should be applied the next day - Normal drying

times apply (24+ hours @ 23°C)