Product Data Sheet Safety Data Sheet Show all documents
SikaCem® Concentrate

SikaCem® Concentrate

General purpose bonding agent

SikaCem® Concentrate is a general purpose bonding agent for bonding cement plasters and screeds to concrete, masonry and brick substrates.

  • Provides excellent adhesion of the plaster or mortar to most mineral based substrates.
  • Can be used for new work or repair work.
  • Increases strength and durability.
  • Increases surface hardness and significantly reduces the problem of surface dusting.
  • Will enable a tighter, denser and more uniform surface finish to be achieved on mortars, toppings and renderings.
  • Improves bond of subsequent coatings.
  • Easy to use.
  • Economical.
Where to buy
Product Data Sheet Safety Data Sheet Show all documents

Usage

SikaCem® Concentrate is used:
  • As a bonding agent to bond cement mortars and plasters to concrete, masonry and brick surfaces. 
  • As an additive to cement based mortars and plasters to reduce surface dusting.
 

Advantages

  • Provides excellent adhesion of the plaster or mortar to most mineral based substrates.
  • Can be used for new work or repair work.
  • Increases strength and durability.
  • Increases surface hardness and significantly reduces the problem of surface dusting.
  • Will enable a tighter, denser and more uniform surface finish to be achieved on mortars, toppings and renderings.
  • Improves bond of subsequent coatings.
  • Easy to use.
  • Economical.

Packaging

5 litres

Colour

White liquid

Product Details

Product Information

Chemical Base

Polyvinyl acetate based emulsion

Shelf Life

Six months in unopened original containers when stored as noted below.

Storage Conditions

Store free from frost and below 25°C.  Protect from direct sunlight.

Density

1.05 kg/litre approximately (at 25°C)

Application

Application Information

Ambient Air Temperature

Application temperature min. +5°C to max. +30°C
Consumption

Consumption

As a bonding agent:

  • 1 litre of SikaCem® Concentrate is diluted to make 2 litres of bonding agent.
  • 1 litre of diluted product will cover an area of approximately 3 – 6m2 (depending on surface roughness and porosity).
  • Therefore, 1 litre of SikaCem® Concentrate will cover an area of 6 – 12m2.
Application steps

MIXING

Typical Mixing Ratios (by volume), SikaCem® Concentrate: Water:

  • As a bonding agent for screeds, toppings and rendering: 1 : 1
  • As an additive to reduce surface dusting: 1 : 6

Mix together a measured amount of SikaCem® Concentrate and water to suit the required application (refer to ‘Technical Data’ above).  Stir until well dispersed. When used as an additive to reduce surface dusting:

  • Consideration should always be given, when diluting SikaCem® Concentrate, to the amount of water already present in the sand.
  • Slowly add the diluted SikaCem® Concentrate to the preblended dry sand/cement while mixing continuously.  Mix until a uniform and lump free consistency has been achieved.

CLEANING OF TOOLS

Clean all tools and equipment with water immediately after use. Hardened mortars containing SikaCem® Concentrate can only be removed mechanically.

 

Documents