Product Data Sheet Safety Data Sheet Show all documents
Sikadur® Injectokit LV

Sikadur® Injectokit LV

Low viscosity epoxy crack injection resin

The Sikadur® Injectokit LV system consists of a low viscosity two part epoxy crack injection resin contained in a patented single cartridge with injection nipples, hoses, and air release pins also available. The system is designed for situations where a complete injection system is required.

  • Convenient to use, disposable single cartridge contains both resin and hardener.
  • Safe and clean to use, non return valves avoid leakage and spills.
  • High strength, excellent bond to concrete, brickwork and masonry, either wet or dry.
  • Modular nature, effective and economical use even for the smallest repair.
Where to buy
Product Data Sheet Safety Data Sheet Show all documents

Usage

For injecting cracks in concrete and masonry wherever there is a need to consolidate a structure or exclude water and air from contact with reinforcement. Due to its low viscosity, cracks down to 0.2 mm at the surface can be filled. Ideal for small scale repairs on site. Can be used for insitu or precast concrete elements.  

Advantages

  • Convenient to use, disposable single cartridge contains both resin and hardener.
  • Safe and clean to use, non return valves avoid leakage and spills.
  • High strength, excellent bond to concrete, brickwork and masonry, either wet or dry.
  • Modular nature, effective and economical use even for the smallest repair.

Packaging

The following Sikadur® Injectokit LV components are required for this system and are sold as separate items:

  • Sikadur® Injectokit LV 250g cartridges
  • Sikadur® Injectokit LV hoses
  • Injection nipples
  • Air release pins
  • Epoxy based surface sealer (Sikadur® UA Concrete Fix, Sikadur®-31/-31+, Sika AnchorFix®-3001)

Product Details

Product Information

Chemical Base

Low viscosity two part crack injection resin

Shelf Life

Twelve (12) months from date of manufacture when stored as stated.

Storage Conditions

Store in original containers at +10°C to +40°C in dry conditions.

Viscosity

10°C

20°C

30°C

400-800 mPas

250-500 mPas

100-250 mPas
Technical Information

Compressive Strength

>70 N/mm2 (After 7 days curing at 20°C)

(BS 6319)

Modulus of Elasticity in Compression

~3,9000 MPa

(EN 527-1/2)

Tensile Strength

>55 N/mm2 (After 7 days curing at 20°C)

(ISO 527)

Tensile Adhesion Strength

When tested to BS3900 Pt E10 in both dry and wet states is greater than normal concrete.

Application

Application Information

Pot Life

+10°C

+20°C

+30°C

+40°C

Pot Life

100 mins.

50 mins.

25 mins.

15 mins.

Set Time

12 hours

7 hours

5 hours

3 hours
Application steps

SUBSTRATE PREPARATION

The surface sealant needs to retain the injection system under pressure. Care must be taken to provide a bond surface which is clean, dry, sound and free from contamination by oil or grease.

CLEANING OF TOOLS

Uncured product on tools and application equipment should be cleaned using Sika Thinner C. Hardened marterial can only be mechanically removed.

Documents