Product Data Sheet Safety Data Sheet Show all documents
Sika® Formol

Sika® Formol

CONCRETE FORM RELEASE AGENT

Sika® Formol is a chemical release agent that has been designed and formulated to function as a bondbreaker between formwork or moulds and freshly placed concrete.

  • Effective on both steel and timber moulds
  • Allows for fast and easy striking of formwork
  • Very economical and easy to apply through conventional spray equipment
  • Highly stable during placement and vibration of concrete
  • Does not stain or contaminate the finished concrete surface
  • Regular use will help to reduce the incidence of rust on steel moulds
Where to buy
Product Data Sheet Safety Data Sheet Show all documents

Usage

Sika® Formol is primarily used as a general purpose release agent on the construction site. It is ideal for application to a wide range of surfaces such as timber, steel or fibreglass.  

Advantages

  • Effective on both steel and timber moulds
  • Allows for fast and easy striking of formwork
  • Very economical and easy to apply through conventional spray equipment
  • Highly stable during placement and vibration of concrete
  • Does not stain or contaminate the finished concrete surface
  • Regular use will help to reduce the incidence of rust on steel moulds

Packaging

5 litres, 20 litres and 200 litres

Colour

Blue/green liquid

Product Details

Product Information

Shelf Life

Twelve (12) months from date of manufacture when stored as stated.

Storage Conditions

Store in unopened original containers in dry conditions between +5°C and +30°C. Keep containers closed and in a well ventilated area when not in use. Do not expose to direct sunlight in storage.

Density

~ 0.85 kg/litre

Flash Point

80.5°C

Application

Consumption

Consumption

Timber ‐ up to 19 m²/litre
Steel ‐ up to 30 m²/litre

 
Application steps

APPLICATION

  • Sika® Formol is supplied ready to use and should not be diluted.
  • Surfaces to be coated should be clean and free from grease, dirt or old concrete.
  • The optimum method of application is by conventional spray equipment, however, a brush or roller can also be used.
  • Sika® Formol should be applied at the stated coverage rates to obtain a thin and even film over the entire surface of the mould or formwork.
  • Any excess liquid remaining on the surface after application should be mopped off. Allow 1 ‐ 3 hours to dry before pouring concrete.

Documents